Honeywell EQUIP HD4DIP, Reference Manual, Page: 27 / 82

HD4DIP Network Camera V2.1 Reference Guide
Document 800-04191 Rev A 27
06/09
Note You can connect your camera to a network or connect it directly to a PC or
laptop using a crossover cable.
Restore Factory Defaults
Your HD4DIP(X) Network Camera has a Factory Reset switch located inside the camera
(see
Figure 2-5 ). Use this switch to restore your camera options and passwords to their
default settings. Use a pin or straightened paperclip to press and hold the Reset switch for
three seconds.
Replacing the Gimbal
Replace the gimbal by reinserting the black tabs into the black clips before installing the
dome enclosure.
Adjusting the Camera FOV (Field of View)
To adjust the HD4DIP(X) camera:
1. Apply power to the camera and watch the video on a connected spot monitor (see
Figure 2-4 to connect a spot monitor).
2. Loosen the setscrew that locks the gimbal assembly in place (see Figure 2-9 ) to
adjust the horizontal rotation.
3. Adjust the camera carrier to the desired view.
4. Re-tighten the locking screw to lock the gimbal assembly in place.
Note Orient the camera as shown in Figure 2-9 to maintain the correct picture
orientation.