Honeywell EQUIP HD4DIP, Reference Manual, Page: 28 / 82

28
Installation and Setup
Figure 2-9 Gimbal Adjustment
Adjusting the Lens Focus
Lenses are pre-focused at the factory. They may require a final adjustment after installation
in the unlikely event the optical effect of the dome camera causes a slight defocusing of the
lens.
TECH TIP! To check the focus, hold the dome over the lens while making any adjustments.
To adjust the camera direction, view angle and focus, connect the service monitor cable
(supplied) to the video monitor output.
Legend
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation
Angle view
Top view
B
C
A
Setscrew (loosen to
adjust horizontal
rotation)
Loosen locking screw (inside
conduit entry) to remove the
side conduit plug.
Set focus
(top)
Set focal length
(bottom)