Honeywell EQUIP HD3MDIP, User Manual

Page: 26 / 80

26
Installation and Setup
3. Adjust the gimbal assembly to the desired view.
4. Re-tighten the locking screw to lock the gimbal assembly in place.
Note Orient the camera as shown in Figure 2-8 to maintain the correct picture
orientation.
Figure 2-8 Gimbal Adjustment
Adjusting the Lens Focus
Lenses are pre-focused at the factory. They might require a final adjustment after
installation because the optical effect of the bubble might cause a slight defocusing of
the lens.
TECH TIP! To check the focus, hold the bubble over the lens while making any adjustments.
To adjust the camera direction, view angle, and focus, connect the local video out to the
video monitor using the supplied BNC video cable.
Angle view
Top view
Setscrew (loosen to
adjust horizontal
rotation)
Loosen set screw to adjust
Tilt Rotation (A) Set focal length
(bottom)
Legend
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation