Honeywell EQUIP HD3HDIHX, User Manual, Page: 24 / 116

24
Installation and Setup
Figure 2-7 Wiring Connection Shown on Board
Connecting to a Video Monitor
The local video out (see Figure 2-7 ) is available as a test output and should be used as
needed during installation to position, aim, and focus the camera. Use the provided BNC
connector to connect the video from the camera to the video input connector on your video
monitor.
Note If your installation involves a 24 V AC power source, then please wait
approximately 60 seconds after connecting to a power source for video to
appear on the local video out.
Connecting to a Network via an RJ-45 Ethernet Connector
The main video connection for your HD3 series camera will be made through your Ethernet
network connection. Connect the
Ethernet connector on your camera to your network
using an Ethernet (10Base-T, 100Base-TX) cable.
Local video out connector
(for aim and focus)
RJ45 Ethernet Connector
(see
Connecting to a Network via
an RJ-45 Ethernet Connector , page
24 )
Factory reset button
Inside view
of camera