4
‘Efficient Daily Use’
PROGRAMMING THE CMR707
Reviewing the Heating Program
To review or edit the heating program use
the
PROGRAM
or
buttons to navigate
between the 4 individual programming periods
for that day. Use the
DAY
button to step through
each day of the week, so the complete 7 day
heating program can be reviewed or edited.
Modifying the Heating Program
To change the heating program:
a.
Press either of the
PROGRAM
or
buttons to enter the programming mode.
The time / temperature settings for period
on Monday (Day 1) will be flashing as
shown. The active period is highlighted by
a flashing square around the numbers at the
bottom of the screen and the selected day
is shown with the day indicator.
b.
To adjust the period start time use the
or buttons, the ‘OK?’ indicator will be
displayed to confirm the change. Holding the
button down will change the time quickly.
Note:
If you are pressing the or
buttons and the display flashes the next
period, it means the next period will be
pushed forward.
c.
Once the required time is reached press
the green
button to confirm.
Note:
If the original time setting did not
require adjustment press the green
button to move to step
‘d’
.
d.
The temperature setting for period
on
Monday (Day 1) will now be flashing. To
adjust this press the or buttons and
confirm the setting again by pressing the
green
button.
e.
The next time and temperature period will
now be active. Adjust this by repeating
steps b - d above until all 4 periods are set
for Monday or press the
AUTO
button to
run the program as set, at any time.
You now have a choice of how to set the
program for the next day:
f.
i) Press the
COPY DAY
button to copy
Monday’s program into Tuesday. The display
will go blank apart from the ‘non flashing’
day indicator, which indicates the day
copied and the ‘flashing’ target day to copy
the program to. To accept this day press the
green
button. To select a different target
day press the
DAY
button until the ‘flashing’
day indicator is under the required day, then
accept it by pressing the green
button.
Note:
Once the target day is confirmed it
becomes the day that is copied if the
COPY
DAY
button is pressed again.
OR
ii) Press the
DAY
button to move the day
indicator to Tuesday (Day 2). The program
for that day can then be adjusted by following
steps
b to e
. Programs for the remaining days
can be set in the same way, using the
DAY
button to move to the next day.
To exit the programming mode select the
desired operating mode by pressing the
AUTO
,
MAN
or
OFF
buttons.
Note:
To run the
adjusted program select the
AUTO
mode.
Disabling / Enabling Time Periods
The thermostat has 4 periods each day that
can be programmed, but you may not need
all of these switch points for your heating
requirements. Therefore, any period from 2
to 4 can be removed from (or returned to) the
heating program profile.
To disable or enable time periods:
a.
To disable unwanted periods go to the
desired period (
to
4
) using the
PROGRAM
or
buttons to navigate,
ensure the correct period is highlighted
with the flashing square symbol. Press and
hold the button for at least 2 seconds
and the display will indicate the period has
been removed from the program.
b.
To enable periods again follow the same
procedure as above, navigating to the
already disabled period. To enable this
period again press and hold the button
for at least 2 seconds.
1
2
3
4
5
6
7
4
