3
USE & OPERATION (CONTINUED)
EN
FUNCTION BUTTONS (CONTINUED)
MODE (COOL)
Press the MODE button to select COOL mode. Pressing the MODE button until COOL is illuminated
on the control panel activates evaporative cooling. The water pump will operate and you will feel the
cooler air after the Honeycomb Cooling Media is completely wet.
Pressing the MODE button again will deactivate COOL light on the control panel, switching off both
evaporative cooling function altogether.
Note:
When the cooling function is switched OFF, the unit can still function in a fan only mode
(without evaporative cooling).
In cooling mode, Honeywell Air Coolers provide cool, moist air through the
evaporation of water.
There is a manual Water Regulator knob located in
the ice compartment of the unit. This allows you
to adjust the amount of
water pumped over the Honeycomb Cooling Media, thus helping to control
cooling and humidification levels.
When the Water Regulator is set to MIN, the water pump distributes a
minimal amount of
water to the Honeycomb Cooling Media. This
results in
less water evaporation and reduces the cooling effect.
When the Water Regulator is set to MAX, the water pump distributes
the maximum amount of water to the Honeycomb Cooling Media. This
results in maximum water evaporation and the cooling performance
improves.
ROOM COOLING AND HUMIDIFYING
Water Regulator
MAX
MIN
