BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN
EN1B-0198GE51 R0801
29
If this is the very first run of the device, then the
Copyright notice is followed by the query for the
root user
password. At the
Old password:
prompt just hit the Enter-Key.
Once a password has been defined the BNA prints
the information
User 'root' logged in.
for
all future startups.
The
root user
is the administration user with
unlimited access rights. The
root user
will be logged
in automatically without any login procedure when
connecting to the BNA device via the serial link
(RS232). Any connection to the BNA via LAN is
password protected!
If the device already contains an application
firmware, then it is necessary to put the device into
the
Stay in Bootloader Mode
prior to the setup
activity (refer to chapter
6.3 Switching the Operating
Mode
on
Page 25
how this can be done).
To prepare the BNA device to operate on the LAN
and to load the application firmware into the
device, the following mandatory commands must
be executed in the order they are listed (for a
detailed command description, refer to chapter
6.5 Command Description
on
Page 31
):
np
Basic network parameters
Definition of IP address, network mask
and default gateway. These definitions
are required to allow the BNA device to
operate on the LAN.
Summary of Contents for BNA-1C
Page 53: ......