Ademco
K9230V3
5820L Interior of box
File: K9230V3_Blueline_Ademco_5820L_instruct_interior.eps
Battery Information
NOTE
FOR DOCUMENT
A
TION
AND ONLINE SUPPORT
http://www
.security
.honeywell.com/hsc/resources/MyW
ebT
ech
FOR W
ARRANTY
INFORMA
TION GO T
O
:
http://www
.security
.honeywell.com/hsc/resources/wa
See inside of
carton for
installation
instructions.
See inside of
carton for
installation
instructions.
REFER TO THE INSTALLATION
INSTRUCTIONS FOR THE CONTROL
WITH WHICH THIS DEVICE IS USED,
FOR DETAILS REGARDING
LIMITATIONS OF THE ENTIRE
ALARM SYSTEM.
1.
2.
3.
5820L is a single-zone Slim-Line
Door/Window contact transmitter
that provides wireless notification
of intrusion.
Install mounting screws
in the two outside
mounting holes as
shown in the diagram
using a #1 Phillips.
If the case-back tamper
switch will be used,
install a third screw in
the middle hole.
Mount the magnet
(supplied) adjacent to
the two vertical
positioning lines on the
case side (see diagram).
The gap can be one-half
of an inch maximum.
To reinstall the cover,
position the cover so
that it covers the
mounted case-back, and
snap-shut. The two case
halves can only be fitted
together in one direction.
Temporarily mount the 5820L
and magnet using the double-
back tape provided.
If the Go/No Go test was
successful, remove the
transmitters cover by inserting
the flat blade of a small screw-
driver into the opening slot at
one end of the unit as shown
in the diagram and separate the
two halves.
The 5820L must only be
mounted against a flat surface.
A curved surface would cause
undo stress to the unit and
possible failure to operate
properly.
4.
5.
6.
7.
Before mounting permanently
using the double-back tape or
mounting screws, conduct a
Go/No Go test to verify adequate
signal strength and reorient or
relocate the transmitter if necessary
NOTE
Installation
Alkaline Battery Will Yield Less
Battery Life than Lithium
Replace battery only with:
Energizer L92 AAA Lithium or
AAA Alkaline, Duracell MX2400,
Panasonic AM-4PI,
Eveready Engeriger EN92.
BATTERY CAUTION: Risk of fire,
explosion and burns. Do not
recharge, disassemble, heat above
212 F (100 C) or incinerate.
Dispose of used batteries properly.
Keep away from children.
Perforation (1/4 x 1/8)
MAGNET
OPENING
SLOT
GAP
0.5" MAX
MAGNET ALIGNMENT
LOCATORS
Do NOT attempt to remove
the PCB from the plastic
cover for any reason.
NOTE
During the programming of the
control panel transmitter must be
enrolled as Input Type 3,
Supervised RF), Loop 1.
NOTE
Observe correct polarity.
FCC / IC Statement:
This device complies with Part 15
of the FCC Rules, and RSS 210 of
IC. Operation is subject to the
following two conditions: (1) This
device may not cause harmful
interference (2) This device must
accept any interference received,
including interference that may
cause undesired operation.
Cet appareil est conforme à la
partie 15 des règles de la FCC &
de RSS 210 des Industries
Canada. Son fonctionnement est
soumis aux conditions suivantes:
(1) Cet appareil ne doit pas causer
d' interferences nuisibles. (2) Cet
appareil doit accepter toute
interference reçue y compris les
interferences causant une
reception indésirable.