SPECIFICATIONS
Transmission Frequency:
345MHz
Unit Dimensions:
2-1/4”W (57mm) x 1-1/2” H
(38mm) x 0.5”D (12.7mm)
+ POS. end
must face down
+ POS. end
must face down
INSTALLING THE BATTERIES
Battery: Use only Duracell DL2025 or ADEMCO
supplied batteries.
Battery Access:
1. Put the alarm system into the TEST mode by
entering your user code plus the number 5
(TEST) on the keypad. While the alarm system is
in the TEST mode, the keypad will beep every 30
seconds.
2. Remove case back by inserting the blade of a
small screwdriver into the seam around the case
and prying the case open.
3. Remove the existing batteries by prying them out
with a small screwdriver.
4. Push new batteries into case back locations (see
diagram). The + POS side must face down.
5. Close by snapping case front and back together.
6. Exit the alarm system TEST mode by entering
your user code plus the number 1 (OFF).
Important Note:
Do not remove Printed Circuit
Board.
Figure 2. Battery tabs shown
Blue
Red
Figure 3. 5804 shown open,
buttons facing down.
FCC STATEMENT
FCC ID: CFS8DL5804
CANADA: 1748101619 5 3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference. (2) This device must accept any interference received,
including interference that may cause undesired operation.
FOR WARRANTY INFORMATION, AND FOR DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM
SYSTEM, REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS
DEVICE IS USED.
165 Eileen Way, Syosset, New York 11791
Copyright © 2004 Honeywell International Inc.
www.honeywell.com/security
ÊN7674V2pŠ
N7674V2 5/04 Rev. A
WWW.DIYALARMFORUM.COM
