Page 12
To reset the lock to the original factory settings including the Programming Code
and all User Codes remove one battery for 10 seconds. Reinsert the battery and
wait for a long and short beep. Press 3 times within 3 seconds. The lock will beep
and the light indicator will turn green.
Beeps and LED flashes red for 5 seconds. Replace with good quality alkaline batteries.
Note: Removing batteries does not erase active Programming or User Codes.
RESTORE FACTORY SETTINGS
LOW BATTERY WARNING
UC
PC
NOTE: If you only press the
for more than 3 seconds but
do not input
PC
, the system will remain in Vacation Mode.
With Vacation Mode enabled, the system enters into low-power comsumption mode.
During this mode, all buttons and functions including the remote controll will be invalid
until they are re-enabled (see steps below).
ENABLE:
DISABLE:
To disable the Vacation Mode, you must press and hold for more than 3 seconds,
then input to unlock the door. Vacation Mode is now disabled.
VACATION MODE
Hear 1 beep and Light Indicator illuminates green then lock door
10 1
PC
PC
You can “mute” or turn the “sound on” on your lock by entering the following.
(Factory setting is sound on).
Sound Off (1) - Light Indicator illuminates green.
Sound On (2) - Hear 1 beep and Light Indicator illuminates green.
6 1 or 2
SOUND ON AND OFF
PC
1 = Sound Off
2 = Sound On
Warning sounds and LED flashes red after 4 incorrect code attempts: Keypad shuts
down for 30 seconds.
SECURE LOCK-OUT PERIOD
Summary of Contents for 8712009
Page 18: ...Page 16 BACK OF TEMPLATE ...
