3
UNLOCK & OPEN YOUR NEW SAFE
DOOR HANDLE
The handle spindles have been shipped inside the Styrofoam cover on the outside of the safe
door and should be installed before opening safe the first time.
UNLOCK AND OPEN THE SAFE
1.
Always make sure that the spindle handle is turned counterclockwise to the left before
entering code.
2.
Enter the preset factory code “1 2 3 4 5 6” followed by # key into the keypad.
3.
If the correct code is entered, the keypad will beep once, the green LED will light up and
you will hear a click indicating the spindle handle can be turned to the right (clockwise) to
open. NOTE: You have approximately 5 seconds to open the safe. If you wait any longer,
the safe will relock and you will have to reenter the code to open.
SECURE LOCKOUT PERIOD
If the wrong code is entered into the keypad 4 consecutive times in a row, the keypad will
automatically revert to the lockout mode and you will not be able to open the safe using the
digital keypad for 3 minutes. During the lockout period entry can be made using the
emergency override key. Continued entry of the wrong code will cause additional 3 minute
lockouts until the proper code is entered.
PROGRAMMING NEW USER CODE
CHANGING THE USER CODE
1.
Using the factory preset code, “1 2 3 4 5 6” followed by #
key, unlock the safe and open the door.
2.
Locate and press the small red reset button (see
illustration) on the back of the door and the keypad will
beep twice and the green LED will light up.
3.
Input a new 3-8 digit passcode followed by the # key and
the green LED will light up once.
4.
Reenter the same code a second time followed by the #
key. If the new code has been properly entered and
accepted the green LED will flash twice and the keypad will
beep twice.
5.
This new personal passcode replaces the preset code and
the preset code will no longer open the safe.
TEST NEW PASS CODE
1.
With door open, rotate handle counterclockwise to put door bolts in lock position.
2.
Enter new code (3 to 8 digits) followed by “ # ”.
3.
Green light is on; rotate handle clockwise within 5 seconds.
4.
Lock bolts should recede into the unlocked position.
OPENING/CLOSING THE SAFE WITH NEW PASSCODE
1.
Make sure the spindle handle is positioned to the left and enter your new code into the
keypad followed by the # key.
2.
The keypad will beep once, green LED will light up and the lock will click. Turn the handle
clockwise to the right to open the safe.
3.
To lock, close the door and turn the spindle handle counterclockwise to the left.
