Honeywell 30 Series, Manual

Page: 98 / 113

84
Honeywell 30 Series IP Cameras User Guide
Figure 97 Access List
General Settings
Concurrent user number : Simultaneous live viewing for 1~10 clients (including main
stream to third stream). The default value is 10.
Filter
Enable access list filtering : Check this item and click SAVE to enable the access list
filtering function.
Filter type : Select Allow or Deny as the filter type.
•
If you choose Allow , only those clients whose IP addresses are on the Access List
below can access the camera, and the others cannot.
•
If you choose Deny , those clients whose IP addresses are on the Access List below
will not be allowed to access the camera, and the others can.
Click ADD and you can add a rule to the following Access List .
Single : This rule allows the user to add an IP address to the Allowed/Denied List .
Network : This rule allows the user to assign a network address and corresponding
subnet mask to the Allow/Deny List . The address and network mask are written in CIDR
format.
Range : This rule allows the user to assign a range of IP addresses to the Allow/Deny
List .
Note:
The IPv6 access list column will not be displayed unless you enable IPv6 on the
Network page. For more information about IPv6 settings, see Enable IPv6 on page
43
.
The Range rule only applies to IPv4 addresses.