1 2 3 4 5 6 7 8
Preparation
Camera Mounting
Camera Adjustment
3. Connect the Wiring
Surface Mount
Optional Camera Settings
1
2
3
1. Remove the Dome Cover
2. Prepare the Mounting Surface (Surface or Flush Mount)
a.
Gently turn the dome cover counter-
clockwise to unlock, then pull free of
the housing. If required, loosen the
security screw first.
b.
Gently pull the inner liner free of the
two notches in the housing.
c.
Set the dome and liner aside.
a.
Connect the video output
connector.
b.
Connect the 24 VAC/12 VDC power
connector.
24 VAC/12 VDC power connector
Video output connector
4S Electrical Junction Box
a.
Secure the adapter plate to the
electrical box using appropriate
screws (not supplied).
b.
If necessary, tuck Video/Power and
BNC cabling into notch.
c.
Secure camera base to ceiling or wall
with 3 screws, supplied.
Adapter plate
Electrical box
(not supplied)
Base
Use camera base or mounting
template to:
a.
Mark the holes as
required.
b.
Insert screw anchors into
holes.
Flush Mount
a.
Surface mount: Secure skirt to ceiling or wall
using appropriate screws, not supplied.
b.
If necessary, tuck Video/Power and BNC
cabling into notch.
c.
Surface mount: Secure camera base with M3
screws, supplied.
Flush mount: Secure camera base with
appropriate M3 screws, not supplied.
Skirt
Adapter plate
Legend
A = Tilt rotation
B = Horizontal rotation*
C = Pan rotation
.
Picture Brightness
The LEVEL screw compensates for the iris level. L (low) darkens the
picture. H (high) brightens the picture.
Phase Adjustment
The V Phase Adjustment Pot adjusts the phase difference between
cameras. Switch 7 must be ON to activate Line lock (AC only).
DIP Switches
(Refer to your
camera model)
Default settings are
shown in bold.
SW
High Res + TDN
High Res
Std Res
1
DC/AES
DC/AES
DC/AES
2
AWB/ATW
AWB/ATW
AWB/ATW
3
BLC ON/OFF
BLC ON/OFF
BLC ON/OFF
4
AGC ON/OFF
AGC ON/OFF
AGC ON/OFF
5
TDN
Not used
FLK
6
FLK ON/OFF
FLK ON/OFF
LL ON/OFF
7
LL ON/OFF
LL ON/OFF
Not available
8
Not used
Not used
Not available
Mode setting
DIP switches
After
➋
mounting and
➌
adjusting the camera, attach the
dome cover:
a.
Attach the inner liner to the base until
the liner clicks into place.
b.
Align the dome cover with the three
dome tabs on the unit.
c.
Turn the dome gently clockwise until it
locks into place.
d.
If desired, secure the dome to the base
with the security screw (see picture).
= ON
= OFF
Monitor out
V-Phase
Level
+
–
H
L
Notch
Notch
Notch
Zoom lever
(bottom)
Focus lever
(top)
Security
screw
B
C
A
* If necessary, loosen the screw
that locks the gimbal assembly in
place, before adjusting the
camera.
Setscrew
Base
Base
Screws
(not supplied)
M3 screws
(not supplied)
M3 screws
(supplied)
Screws
(not supplied)
Screws
(supplied)