Honeywell 2020, User Manual, Page: 67 / 284

3 - 11
Resetting the Standard Product Default Settings:
All Application Work Groups
The following barcode defaults all of the work groups to the factory settings.
The Menu Commands, beginning on page 12-5 list the standard product default
settings for each of the commands (indicated by an asterisk (*) on the program-
ming pages).
Resetting the Standard Product Default Settings:
Current Application Work Group
If you aren’t sure what programming options are in your image scanner, or
you’ve changed some options and want the standard product default settings
restored, scan the
Standard Product Default Settings: Current Application
Group barcode below.
The Menu Commands, beginning on page 12-5 list the factory default settings
for each of the commands (indicated by an asterisk (*) on the programming
pages).
Note: Scanning this barcode also causes both the image scanner and the base
to perform a reset and become unlinked. The image scanner must be
placed in its base to re-establish the link before any setup codes are
entered. Refer to
"Image Scanner Modes" on page 3-5 for additional
information.
Note: If your image scanner is in multiple image scanner mode and you scan
either the current or all application group default barcode, you will hear up
to 30 seconds of beeping while all image scanners are re-linked from the
base and the settings are defaulted to * settings. The default interface is
keyboard wedge and the default image scanner mode is single image
scanner locked link mode.
Standard Product Default Settings:
All Application Groups
Standard Product Default Settings:
Current Application Group