range to within
degrees F
pecified throttling range for
either the throttling range
adjustment or calibration screw were changed,
recalibrate the Thermostat.
See TP970
B, beginning at Step
1,
for the
balance of TP970C and 5 calibration.
P a ) main line pressure, turn the DAY
ssure, repeat Steps
ostat is not properly c a l i b r a t e d , but the remainder
tur n the calibration screw
midist/Thermostat operation
essure is set to the low
(1 3
0 psi (0 kPa) (RA) or 13 psi (90 kPa) (DA).
TP972A:
0 psi (0 kPa).
If it does not, turn the switchover adjustment screw
(Fig. 20) clockwise until it does.
Turn the switchover adjustment screw counterclockwise
until the pressure begins to:
TP971A, B, D, AND, E:
Increase (RA) or decrease (DA).
TP972A:
Increase.
This indicates switchover.
Allow the Pressure Gage to go to:
TP971A, B, 5, AND, E:
Full main line pressure (RA) or 0 psi (0 kPa) (DA).
TP972A:
Full main line pressure.
Turn the switchover adjustment screw counterclockwise
until the
pressure:
i (0
kPa) (RA) or increases to
full main line pressure (DA).
TP972A:
Decreases to 0 psi (0 kPa).
Turn the switehover adjustment screw an additional 1/8
to 1/4-turn clockwise.
BACK PLATE
SCREWS
MOST-AT
MULTISTAGE
FILTER
SWITCHOVER
SCREW
Summary of Contents for 14002573-001
Page 6: ...NO 6 IN 2 MAIN ...
