28
Operating Manual IK3 Operating Unit with Keypad
8.8
Define / alter PIN
Use the "i" key for this function, otherwise other combinations would immediately trigger an action if a
IK data carrier is held in the reading range.
Possible number of digits of a PIN: 4 to 8 digits.
The minimum number of digits is determined by the installer in compliance with the VdS class.
If several PINs are used, they must all have the same number of digits.
Observe the following when defining / altering PINs:
A PIN is allocated to the corresponding IK data carrier (or multiple use of a PIN, see Chapter 9
"Appendix".)
Acknowledgement is negative if there is no authorization, if an attempt is made at defining an already
existing PIN (not with multiple use) or the PIN corresponds with a hold-up code.
i
0....9
0....9
IK-D
Define PIN
i
Alter PIN
A)
or
B)
i
Activate the " " key
Hold the IK data carrier in the reading range
Current state is indicated (see "Info" 8.5)
Activate "OK"
"Alarm" indicator lights up green
Enter new PIN
Activate "OK"
Re-enter PIN
Activate "OK"
"Alarm" indicator goes off
Activate the " " key
Hold the IK data carrier in the reading range or enter
the PIN used so far
Current state is indicated (see "Info" 8.5)
Activate "OK"
"Alarm" indicator lights up green
Enter new PIN
Activate "OK"
Re-enter PIN
Activate "OK"
"Alarm" indicator goes off
3
3
3
3
0....9
3
0....9
3
i
IK-D
i
0....9
0....9
0....9
3
3
3
EU BUS-2 with V03.02:
If PINs are used several times, the PIN alteration must be started with the IK data carrier (A). If the
alteration is started with PIN, a negative acknowledgement follows.
EU BUS-2
up to V03.02
