Installation
1.
Attach the side collar and speedometer
gearbox to the front wheel.
2.
Position the wheel between the fork legs
and insert the front axle shaft from the
right side, through the right fork leg and
wheel hub.
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
3.
Make sure that the lug on the right fork
leg is located in the slot of the
speedometer gearbox.
4.
Tighten the front axle nut.
Torque:
44 N·m (4.5 kgf·m, 32 lbf·ft)
5.
After installing the wheel, apply the brake
lever several times, and then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel dose not
rotate freely.
6.
Install the speedometer cable and tighten
the speedometer cable set screw securely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
20171023164032_32KRHH100_eng_BOOK Page 83 Monday, October 23 2017 17:21:44 JST
Tyre Puncture
u
Removing Wheels
Troubleshooting
80
Slot
Lug
