Honda SH300I 2006, Manual

Page: 61 / 511

FRAME/BODY PANELS/EXHAUST SYSTEM
3-3
SERVICE INFORMATION
GENERAL
• This section covers removal and installation of the body panels and exhaust system.
• When installing the covers, make sure the mating areas are aligned properly before tightening the fasteners.
• Always replace the exhaust pipe gasket after removing the exhaust system.
• When installing the exhaust system, loosely install all of the fasteners. Always tighten the exhaust joint first, then
tighten the mounting fasteners. If you tighten the mounting fasteners first, the exhaust pipe may not seat properly.
• Always inspect the exhaust system for leaks after installation.
TORQUE VALUES
TROUBLESHOOTING
Excessive exhaust noise
• Broken exhaust system
• Exhaust gas leak
Poor performance
• Deformed exhaust system
• Exhaust gas leak
• Clogged muffler
Luggage box mounting bolt 10 N·m (1.0 kgf·m, 7 lbf·ft)
Luggage box mounting washer bolt 10 N·m (1.0 kgf·m, 7 lbf·ft)
Front fender mounting bolt 12 N·m (1.2 kgf·m, 9 lbf·ft)
Rear view mirror lock nut 34 N·m (3.5 kgf·m, 25 lbf·ft)
Exhaust pipe stud bolt 9 N·m (0.9 kgf·m, 6.6 lbf·ft) See page 3-15
Exhaust pipe joint nut 29 N·m (3.0 kgf·m, 21 lbf·ft)
Exhaust pipe band bolt 22 N·m (2.2 kgf·m, 16 lbf·ft)
Muffler mounting bolt 49 N·m (5.0 kgf·m, 36 lbf·ft)
Sidestand pivot bolt 10 N·m (1.0 kgf·m, 7 lbf·ft)
Sidestand pivot nut 30 N·m (3.1 kgf·m, 22 lbf·ft) U-nut.