Honda SH300I 2006, Manual

Page: 428 / 511

BATTERY/CHARGING SYSTEM
19-6
BATTERY
REMOVAL/INSTALLATION
Always turn the
ignition switch OFF
before removing
the battery.
Remove the maintenance lid (page 3-4).
Remove the bolts and battery holder plate.
Disconnect the
negative terminal
first, then the posi-
tive terminal.
Remove the bolt and disconnect the negative (–)
cable.
Remove the bolt and disconnect the positive (+)
cable.
Remove the battery.
Install the battery in the reverse order of removal.
After installing the battery, coat the terminals with
clean grease.
Install the maintenance lid (page 3-4).
VOLTAGE INSPECTION
Remove the maintenance lid (page 3-4).
Measure the battery voltage using a digital
multimeter.
If the battery voltage is below 12.3 V, charge the bat-
tery.
BATTERY HOLDER PLATE
BOLTS
Connect the posi-
tive terminal first,
then the negative
terminal.
POSITIVE (+)
CABLE
NEGATIVE (–)
TERMINAL
BATTERY
VOLTAGE:
Fully charged: Above 12.8 V
Needs charging: Below 12.3 V
NEGATIVE (–)
TERMINAL POSITIVE (+)
TERMINAL