Honda SH300I 2006, Manual

Page: 334 / 511

FRONT WHEEL/SUSPENSION/STEERING
15-20
Install the fork pipe cap on to the fork pipe.
INSTALLATION
Install the fork leg into the steering stem and align
the fork pipe groove with the bolt hole, then install
the upper pinch bolt.
Tighten the upper/lower pinch bolts to the specified
torque.
Left fork only:
Install the brake caliper with new mounting bolts
and tighten the bolts to the specified torque.
Install the following:
– front fender (page 3-8)
– front wheel (page 15-10)
HANDLEBAR
REMOVAL
Remove the following
– front upper cover (page 3-9)
– front handlebar cover (page 3-14)
– rear handlebar cover (page 3-14)
Release the wire band and turn signal relay from the
handlebar.
FORK PIPE CAP
TORQUE: 49 N·m (5.0 kgf·m, 36 lbf·ft)
FORK
BOLTS
Align
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
CALIPER
MOUNTING BOLTS
TURN SIGNAL RELAY
WIRE BAND