Honda SB2040, Operator'S Manual

Page: 15 / 50

Snowblower
Assembly
and
Installation
Discharge Chute Assembly
1. Install the discharge guard on the chute as shown using
two
hex bolts, flat washers,
2.
Place the antifriction ring onto the blower head; the ring is keyed to the blower head
so
only one
3. Apply a generous amount
of
general purpose grease to the top lip of the antifriction ring.
4. Install the long plastic bushing into the worm gear bracket. Apply grease to the inside
lock washers and hex nuts.
position fits.
surface of the bushing.
114
x 314" HEX BOLT (2
DISCHARGE GUARD
HEX NUT (2)
318" LOCK WASHER (2)
318" FLAT WASHER
(2)
114 HEX BOLT (6)
- RETAINING PLATE (3)
PLASTIC BUSHING
WORM GEAR
114" HEX NUT (6)
5. Grease the inside
of
the shorter (1-5/16") plastic bushing then slide it onto the short shaft
of
the
worm
6.
Position the chute on the blower head. Get a helper to hold it in place if needed.
7. Install the two front retaining plates using four 1/4 x hex bolts, lock washers and hex nuts.
gear. Grease the long shaft on the worm gear, and install it into the bushing on the worm gear bracket.
8. Install the short shaft of the worm gear (with bushing) into the
9.
Use the 1/4 x hex bolts to install the left rear retaining plate
10. Apply a generous amount of general purpose grease to the worm
11. Use the longer, 1/4 x hex bolts to secure the right rear
bracket on the blower head.
314" HEX BOLT
along with the crank handle bracket.
gear and chute gear teeth.
retaining plate, hold-down bracket, and the plastic chain cover.
L
114" HEX NUT
POP
521 52 (961 0 )
13