Honda HS1336i, Owner'S Manual

Page: 99 / 144

97
SERVICING YOUR SNOW BLOWER
3. Disconnect the negative (—) cable at the battery A negative (—) terminal and
put the tube on the terminal.
4. Disconnect the positive (
+
) cable at the battery B positive (
+
) terminal and
put the tube on the terminal.
5. Loosen the nuts and lock nuts holding the battery set plate.
6. Disconnect the battery joint cable at the battery B negative (—) terminal and
at the battery A positive (
+
) terminal.
7. Remove the battery and clean the battery terminals and battery cable
terminals with a wire brush or sand paper.
Clean the battery with a solution of baking soda and warm water with care not
to get the solution or water in the battery cells. Dry the battery thoroughly.
NEGATIVE(-) CABLE PO) CABLE
BATTERY JOINT CABLE
BATTERY SET PLATE
NEGATIVE(-)
TERMINAL
PO)
TERMINAL
TUBES
BATTERY B
BATTERY A
NUT
PO) TERMINAL
NEGATIVE(-) TERMINAL
(Two 12V batteries are connected in series/24V)
LOCK NUT
31V156250.book 97 ページ ２０２０年１２月２２日 火曜日 午後１時３６分