113
TRANSPORTING
LOADING
1. Start the engine and raise the auger fully by operating the auger control
switch. Lower the chute guide fully by operating the chute control switch.
2. Before backing up the loading ramp, adjust the position and angle of the
travelling direction of the snow blower so that the snow blower is in direct
alignment with the loading ramp.
3. Set the main shift lever in the SLOW RANGE, and back the snow blower up the
loading ramp at a slow speed.
Use reverse gear to back the snow blower up the ramp. Use extreme care not
to hit the dischage chute against the hood or any other parts of the truck.
Do not hang the snow blower.
Hanging the snow blower could cause damage.
Spilled fuel may ignite. To avoid fuel and oil
spillage, keep the snow blower level when
transporting.
Do not operate the steering lever while
backing the snow blower up the loading
ramp; serious personal injury or damage to
the snow blower could result.
REVERSE
DOWN
UP
H
L
5 ft (1.5 m)
minimum
headroom
31V156250.book 113 ページ ２０２０年１２月２２日 火曜日 午後１時３６分
Summary of Contents for HS1336i
