Honda HRR216VYA, Owner'S Manual

Page: 6 / 24

6
Installation
1. Remove the mulching
plug when using a
grass bag.
2. Raise the discharge
guard and hook the
grass bag onto the
mower deck as shown.
Make sure there are no
grass clippings in the
hook channel.
3. Release the discharge
guard to secure the
grass bag.
Removal
1. Raise the discharge
guard, grasp the grass
bag handle, and remove the grass bag.
2. Release the discharge guard.
3. When the grass bag is clear of the discharge guard, you can lift it
through the handlebar opening, or you can remove it to the rear of
the mower below the handlebar.
Rear Shield
During normal use, the rear shield is subject to deterioration and
wear. Remove the grass bag and raise the discharge guard. Check
the rear shield for cracks or tears. If the rear shield is excessively
worn, have it replaced by your authorized Honda servicing dealer.
Cutting Height
Adjustment
The cutting height figures are
approximate. The actual
height of cut grass will vary
with lawn and soil conditions.
To adjust the cutting height,
pull each adjustment lever
toward the wheel, and move it
into another notch.
Move the adjustment levers in
the same direction to the
desired cutting height position.
If you are not sure what
cutting height to select, start
with a high setting and check
the appearance of the lawn
after mowing a small area.
Readjust the cutting height if
necessary.
GRASS BAG
HANDLE
DISCHARGE GUARD
HOOK CHANNEL
DISCHARGE
GUARD
REAR SHIELD
1-1/4" (28 mm)
1-3/4 " (44mm)
2-1/2" (60 mm)
3" (75 mm)
3-1/2" (90 mm)
4" (102 mm)
FRONT ADJUSTMENT
LEVER (2)
REAR ADJUSTMENT
LEVER (2)