Honda GXE2.0S, Manual

Page: 55 / 59

7-5
dummyhead dummyhead
POWER UNIT
ROTOR SHAFT REMOVAL/INSTALLATION
TOOL FITTING
Install the following and place the assembly on wooden blocks [1].
– [2] Dowel pin (2)
– [3] Tool: Rotor guide (070PG-8A00100)
REMOVAL/INSTALLATION
Push the rotor guide [1] down without wooden blocks to release the rotor
shaft [2].
To install, insert the rotor shaft into the rotor guide while holding it securely
set with wooden blocks [3].
Parts Remarks
[1] BOLT (6 x 20 mm) (4)
[2] TOP COVER
INSTALLATION: Install the cover in the direction as shown.
[3] FAN COVER
[4] NUT (12 mm)
TOOL: [19] COOLING FAN HOLDER (070PB-8A00100)
Tighten the four 6 mm bolts of the tool to 12 N·m (1.2 kgf·m, 9 lbf·ft)
[5] COOLING FAN
[6] MOTOR HOUSING (FAN SIDE)
INSPECTION: Check the dust seal and bearing in the housing for wear or damage.
[7] BOLT (5 x 12 mm) (4)
[8] ROTOR FAN
[9] WOODRUFF KEY (13 x 12 mm)
[10] ROTOR/SHAFT
TOOL: ROTOR GUIDE (070PG-8A00100) (page 7-5)
[11] HOUSING PACKING
[12] SOCKET BOLT (6 x 16 mm) (4)
[13] MOTOR HARNESS STAY (2)
[14] SOCKET BOLT (6 x 40 mm) (3)
[15] STATOR ASSEMBLY
INSPECTION: Check for damage in the stator coils (page 2-6).
INSTALLATION: Set the wires in the grommets properly and install them into the
housing grooves tightly (page 2-6).
[16] DOWEL PIN (6 x 10 mm) (2)
[17] MOTOR HOUSING (P.T.O. SIDE)
INSPECTION: Check the dust seal and bearing in the housing for wear or damage.
[18] BOLT (6 x 50 mm) (8)
[1]
[2]
[3]
[3]
[1]
[2]
[3]