Honda GX270H, Manual, Page: 42 / 182

3-3
dummyhead dummyhead
MAINTENANCE
ENGINE OIL LEVEL CHECK/CHANGE
CHECK
Place the engine on a level surface.
Remove the oil filler cap [1] and check the oil level
shown into the oil filler neck [2].
If the oil level is low, fill with recommended oil to the
upper level of the oil filler neck (page 3-3).
Check that the oil filler packing [3] is in good condition,
replace it if necessary.
Install and tighten the oil filler cap securely.
CHANGE
Place the engine on a level surface and place a suitable
container under the drain bolt [1].
Remove the oil filler cap [2], drain bolt, and sealing
washer [3] and drain the oil into a suitable container.
Please dispose of used oil in a manner that is
compatible with the environment. We suggest you take
used oil in a sealed container to your local recycling
center or service station for reclamation. Do not throw it
in the trash, pour it on the ground, or pour it down a
drain.
Install the drain bolt with a new sealing washer and
tighten it to the specified torque.
Add the specified amount of recommended oil into the
engine.
After adding the oil, check the oil level.
Check that the oil filler packing [4] is in good condition,
replace it if necessary.
Install and tighten the oil filler cap securely.
Make sure there are no oil leaks.
[1]
[3]
[2]
Used engine oil contains substances that have
been identified as carcinogenic. If repeatedly left in
contact with the skin for prolonged periods, it may
cause skin cancer. Wash your hands thoroughly
with soap and water as soon as possible after
contact with used engine oil.
TORQUE: 23 N·m (2.3 kgf·m, 17 lbf·ft)
SAE 10W - 30 is
recommended for
general use. Other
viscosities shown in
the chart may be
used when the
average
temperature in your
area is within the
recommended
range.
OIL CAPACITY: 1.1 Liters (1.16 US qt, 0.97 Imp qt)
RECOMMENDED OIL:
SAE 10W-30
API service classification: SE or higher
SAE VISCOSITY GRADES
AMBIENT TEMPERATURE
[2]
[1]
[4]
[3]
62Z7B000.book 3 ページ ２０１２年９月２７日 木曜日 午前１０時２１分