CONTROLS & FEATURES
27
Overload Alarm Indicator
If the generator is overloaded (in excess of 3.2 kVA), or if there is a short circuit in
a connected appliance, the overload alarm indicator (red) will come ON. The
overload alarm indicator (red) will stay ON, and after about 10 seconds when an
overload or about 5 seconds in case of a short circuit, current to the connected
appliance(s) will shut off, and the output indicator (green) will go OFF. However,
the engine will continue to run.
If the overload alarm indicator (red) blink continuously, press and hold the ECO
Throttle switch to reset it (see page 21).
Oil Alert®/Check Indicator
The Oil Alert®
system is designed to prevent engine damage caused by an
insufficient amount of oil in the crankcase. Before the oil level in the crankcase
can fall below a safe limit or in the case of engine overheat, the Oil Alert/Check
indicator (red) comes ON and the Oil Alert system automatically will stop the
engine (the engine switch will remain in the ON position).
If the engine stops or the Oil Alert/Check indicator (red) comes ON when you
pull the starter grip, check the engine oil level (see page 34) before
troubleshooting in other areas. Also, make sure to install the generator on a
level surface.
The engine may stop due to the activating the oil alert system even if the
engine oil level is the normal when the generator is tilted.
If the Oil Alert/Check indicator (red) blink continuously, it suggests an
abnormal, contact your servicing dealer.
OVERLOAD ALARM INDICATOR
(RED)
OIL ALERT/CHECK INDICATOR
(RED)
Summary of Contents for EU3200i
Page 14: ...GENERATOR SAFETY 12 ...
Page 98: ...96 MEMO ...
