Honda EU10iT1, Manual

Page: 60 / 138

6-7
dummyhead dummyhead
FUEL SYSTEM
THROTTLE STOP SCREW
Install the throttle stop screw [1] after installing the pilot
jet.
Install so that the throttle valve is fully closed and the
screw end does not come out of the bracket.
FLOAT LEVEL HEIGHT INSPECTION
Place the carburetor in the position shown, and
measure the distance between the float top [1] and
carburetor body [2] when the float just contacts the seat
without compressing the valve spring.
If the height is outside the specification, replace the
float and float valve and recheck the height.
PILOT SCREW REPLACEMENT
Only remove the pilot screw [1] and limiter cap [2] when
necessary for repair or for cleaning stubborn deposits
from the pilot circuit passages.
Removal of the limiter cap requires breaking the pilot
screw. A new pilot screw and limiter cap must be
installed.
When the limiter cap has been broken off, remove the
broken pilot screw.
Place the spring on the replacement pilot screw, and
install it on the carburetor.
Turn the pilot screw in until it is lightly seated, and then
turn it out the required number of turns.
[1]
TOOL:
Float level gauge [3]
07401-0010000
FLOAT HEIGHT: 12.0 mm (0.47 in)
[1]
[2]
[3]
Pilot screw opening: 2-5/8 turns out
[2]
[1]
[2]
Pilot screw breaks at narrow point.