Honda Deauville NT700V 2010, Owner'S Manual

Page: 198 / 256

66 lbf·ft (89 N·m , 9.1 kgf·m)
24 lbf·ft (32 N·m , 3.3 kgf·m)
66 lbf·ft (89 N·m , 9.1 kgf·m)
rear axle nut:
axle holding bolt:
rear brake stopper bolt:
191
Taking Care of the Unexpected
If You Have a Flat Tire
Tighten the nut and bolt to the specified
torques:
After installing the wheel, apply the
brake several times. Check for free
wheel rotation after the brake is
released. Recheck the wheel if the brake
drags or the wheel does not rotate freely.
Installation
Before installing the wheel, check that the
wheel hub and final drive gear splines are
coated with molybdenum disulfide paste
( Pro Honda Moly 60 Paste, or equivalent).
Position the wheel between the
swingarm and the final drive gear case.
Be sure the splines on the wheel hub fit
into the final drive gear case.
Install the side collar into the wheel hub.
To avoid damaging the brake pads
while setting the brake caliper
assembly over the brake disc,
carefully fit the brake disc between
the pads.
Insert the rear axle shaft from the left
side, through the left swingarm, rear
brake bracket, wheel hub and final drive
gear case.
Install the rear brake bracket, washer
and rear brake bracket bolt.
(cont’d)
2.
3.
1.
4.
5.
6.
０９／０７／２３ １８：１９：０５ ３１ＭＥＷＡ００ ０２００