Honda CRF450X 2020, Owner'S Manual & Competition Handbook

Page: 114 / 204

106
Servicing Your Honda
Suspension
12. Clean the surfaces where the axle and axle
clamps contact each other.
Apply grease to each dust seal lips of the front
wheel.
Install the left side collar (20) and right side
collar (21) into the wheel hub.
13. Install the front wheel between the fork legs
while inserting the disc between the pads,
being careful not to damage the pads.
• When installing the wheel, be careful not to
damage the wheel speed sensor and pulser
ring.
14. Insert the front axle shaft through the forks and
wheel hub from the right side. Make sure that
the front axle shaft is seated firmly onto the left
fork leg clamp inner surface. Tighten the front
axle nut (22) to the specified torque:
65 lbf·ft (88 N·m, 9.0 kgf·m)
Tighten the left axle pinch bolts (23) to the
specified torque:
15 lbf·ft (20 N·m, 2.0 kgf·m)
15. Route the speed sensor wire (24) properly and
install the speed sensor (25) to the left fork
bracket. Install and tighten the speed sensor
mounting bolt (26).
Install the speed sensor wire guide plate (27)
and tighten the guide plate screw (28).
16. Install the handlebar (29), mounting rubbers,
washers and handlebar lower holder nuts (30)
and tighten the handlebar holder nuts to the
specified torque:
32 lbf·ft (44 N·m, 4.5 kgf·m)
17. With the front brake applied, pump the fork up
and down several times to seat the axle and
check front brake operation.
(20) left side collar (21) right side collar
(20)
(21)
(22) front axle nut (26) bolt
(23) left axle pinch bolts (27) plate
(24) speed sensor wire (28) screw
(25) speed sensor
(29) handlebar
(30) mounting rubbers, washers and handlebar lower
holder nuts
(27)
(28)
(23)
(22)
(24) (25)
(26)
(30)
(29)
(30)
31MKE710.book 106 ページ ２０１９年３月１１日 月曜日 午前１０時４７分