9 lbf·ft (12 N·m , 1.2 kgf·m)
54 lbf·ft (73.5 N·m, 7.5 kgf·m)
RIGHT FRONT
(4) UP mark
(4)
98
Wheels
Servicing Your Honda
Installation
Install the axle holder with the UP mark ( )
upward and first tighten the upper holder
nuts until lightly seated, then tighten the
lower axle nuts until lightly seated.
Operate the front brake and pump the fork
several times.
First tighten the upper holder nuts to the
specified torque, then tighten the lower axle
nuts to the same torque:
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the brake
drags or if the wheel does not rotate freely.
Check front brake adjustment (page
).
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
Reverse the removal procedure. Install the
side collars into the wheel.
Insert the front axle shaft through the wheel
hub and left fork leg.
Tighten the front axle shaft to the specified
torque:
2.
3.
4.
5.
6.
4
1.
7.
87
05/03/30 20:10:41 31KPS630_107
