© 2001 American Honda Motor Co., Inc - All Rights Reserved.
AII 23268 (0110)
7 of 10
Installing the CD Changer
26. Carefully unpack the CD changer. Remove the
three shipping clips, and discard the shipping
cover. Save the shipping clips for your customer
in the event the unit needs to be serviced.
28. Visually check the location of the spring
adjusting pins on both sides of the CD changer.
If the spring adjusting pins are not in the vertical
(V) position, move the pins to the vertical (V)
position with a small flat-tip screwdriver.
29. Remove the backing from the two adhesive
covers, and attach one cover to each side of the
CD changer. Align the two diagonally opposite
holes with the H and V positions.
27. Install an adhesive seal (included with the CD
changer kit) over each of the three clip holes.
FOR VERTICAL
INSTALLATION
SPRING ADJUSTING PIN
VERTICAL POSITION
LEFT LOCKING
COVER
(supplied with
CD Changer kit)
RIGHT LOCKING
COVER
(supplied with
CD Changer kit)
30. Position the front and rear brackets on the CD
changer, and install four 4 x 8 mm washer-
screws into each bracket.
31. Using a utility knife, cut out the inside line of the
center area on the CD changer trim.
4 x 8 mm
WASHER-SCREW
Cut out.
REAR
BRACKET
CD CHANGER
FRONT
BRACKET
4 x 8 mm
WASHER-
SCREW
CD CHANGER
TRIM
OUTSIDE LINE
Do not cut here.
INSIDE LINE
Cut here.
SHIPPING CLIP
ADHESIVE SEAL
SHIPPING COVER
(Discard.)