Honda CBR125R, Owner'S Manual

Page: 70 / 430

MAINTENANCE
3-14
ENGINE OIL CHANGE
Warm up the engine.
Stop the engine and remove the oil filler cap/dip-
stick.
Place an oil pan under the engine to catch the
engine oil, then remove the drain bolt/sealing
washer.
Drain the engine oil completely.
Install a new sealing washer onto the drain bolt.
Apply engine oil to the drain bolt threads and seat-
ing surface.
Install and tighten the drain bolt/sealing washer to
the specified torque.
Fill the engine with the recommended engine oil
(page 3-13).
Install the oil filler cap/dipstick.
Check the oil level (page 3-13).
Make sure there are no oil leaks.
ENGINE OIL STRAINER SCREEN
REMOVAL/INSTALLATION
Remove the right crankcase cover (page 10-5).
Pull the oil strainer screen out of the crankcase.
Wash the oil strainer screen thoroughly in nonflam-
mable or high flash point solvent until all accumu-
lated dirt has been removed.
Blow dry it with compressed air to clean completely.
Before installing the strainer, it should be examined
closely for damage, and make sure the sealing rub-
ber is good condition.
FILLER CAP/DIPSTICK
TORQUE: 25 N·m (2.5 kgf·m, 18 lbf·ft)
BOLT/SEALING WASHER
ENGINE OIL CAPACITY:
1.0 liter (1.1 US qt, 0.9 Imp qt) at draining
1.3 liters (1.4 US qt, 1.1 Imp qt) at disassembly
FILLER CAP/DIPSTICK
Be careful not to
damage the oil
strainer screen.
OIL STRAINER SCREEN