Honda CBR125R, Owner'S Manual

Page: 69 / 430

MAINTENANCE
3-13
ENGINE OIL
OIL LEVEL INSPECTION
Hold the motorcycle in an upright position.
Start the engine and let it idle for 3 – 5 minutes.
Stop the engine and wait 2 – 3 minutes.
Remove the oil filler cap/dipstick and wipe it clean.
Reinstall the oil filler cap/dipstick, but do not screw
it.
Remove the oil filler cap/dipstick and check the oil
level.
If the level is below the lower mark on the dipstick,
fill the crankcase with recommended oil.
Other viscosities
shown in the chart
may be used when
the average
temperature in your
riding area is within
the indicated range.
Check that the O-ring is in good condition, replace it
if necessary.
Apply engine oil to the O-ring and install it to the
filler cap/dipstick.
Install the oil filler cap/dipstick.
FILLER CAP/DIPSTICK
UPPER
LOWER
RECOMMENDED ENGINE OIL (Except CM type):
Honda "4-stroke motorcycle oil" or an equivalent
API classification: SG or higher (except oils labeled
as energy conserving on the circular API service
label)
JASO T 903 standard: MA
Viscosity: SAE 10W-30
RECOMMENDED ENGINE OIL (CM type only):
Pro Honda GN4 4-stroke oil or equivalent motor oil
API service classification: SG or Higher
JASO T 903 standard: MA
Viscosity: SAE 10W-30
FILLER CAP/DIPSTICK
O-RING