Honda CBR125R, Owner'S Manual

Page: 257 / 430

ALTERNATOR/STARTER CLUTCH
11-11
INSTALLATION
Install the starter clutch assembly to the flywheel as
shown.
Apply 6.5
±
0.1 mm (0.26
±
0.04 in) from tip of lock-
ing agent to the starter clutch torx screw threads.
Install the starter clutch assembly onto the flywheel
and install the torx screws.
Hold the flywheel with a special tool and tighten the
torx screws to the specified torque.
Install the starter driven gear while turning it coun-
terclockwise.
Make sure that the starter driven gear turns counter-
clockwise smoothly and does not turn clockwise.
Install the flywheel (page 11-11).
FLYWHEEL INSTALLATION
Clean any oil from the crankshaft taper.
Install the woodruff key onto the crankshaft.
STARTER CLUTCH ASSEMBLY
FLYWHEEL
TOOL:
Flywheel holder
07725-0040001
TORQUE: 16 N·m (1.6 kgf·m, 12 lbf·ft)
TORX SCREWS
FLYWHEEL HOLDER
DRIVEN GEAR
Be careful not to
damage the key
groove and
crankshaft.
WOODRUFF KEY