© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
All 33080-33238 (0607)
5 of 7
3D08111T
3D08160T
3D08080T
Insert.
Lock.
WHITE WIRE
RED WIRE
2-PIN
CONNECTOR
CUSHION
TAPE
LED
HARNESS
UPPER STEERING
COLUMN COVER
UPPER STEERING
COLUMN COVER
5.5 mm BIT
MARK
30 mm
CENTER LINE
PUNCH
DRILL
FELT-TIP
PEN
LED
HARNESS
UPPER STEERING
COLUMN COVER
WIRE TIE
UPPER STEERING
COLUMN COVER
LED
LED
PUSH NUT
(Note the installation direction.)
15. On the inside of the upper steering column cover,
measure and mark the upper steering column
cover.
16. While wearing eye protection, center-punch the
mark; then drill a 5.5 mm hole through the upper
steering column cover. Remove all burrs with a
round file.
17. Route the terminal ends of the LED through the
hole you just drilled, and secure the LED with the
push nut. Install the push nut securely.
18. Using isopropyl alcohol, thoroughly clean the
back of the upper steering column cover in the
area shown. Secure the LED harness to the upper
steering column cover with a cushion tape.
19. Get the 2-pin connector included in the kit. Firmly
push the LED terminals into the 2-pin connector
until they click into position, then lower the lock.
NOTE:
It is important to insert the red and white wires as
shown for the LED to fanction.
20. Reinstall the upper steering column cover, then
secure the LED harness to the vehicle harness
with the wire tie.
21. Route the security system harness 2-pin
