To remove the burned out bulb,
push it in and turn it
counterclockwise until it unlocks.
Install the new bulb and turn it
clockwise to lock it in place.
Insert the socket into the
headlight assembly. Turn it
clockwise to lock it in place.
Put the inner fender cover in place.
Install and lock each holding clip
by pushing on the center.
Test the new bulb to make sure it
works.
Set the lining back.
Remove the socket by turning it
one-quarter turn counterclockwise,
and pull the bulb straight out of its
socket.
Push a new bulb straight into the
socket until it bottoms, and
reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Open the trunk.
Remove the holding clips from the
lining by using a flat-tipped
screwdriver.
Test the new bulb to make sure it
works.
5.
6.
7.
8.
9.
2.
1.
4.
3.
5.
6.
Lights
Replacing Rear Turn Signal Light
Bulbs
222
HOLDING CLIPS
BULB
SOCKET
０６／０５／１６ １４：２６：２８ ３１ＳＤＡ６４０ ０２２７
