©
2003 American Honda Motor Co., Inc - All Rights Reserved.
AII 25460 (0310)
3 of 5
Installing the LED
6.
Using the tape measure, measure and mark the
inside of the upper steering column cover.
8.
Route the terminal ends of the LED through the
hole you just drilled, and secure the LED with the
push nut. Install the push nut securely.
9.
Locate the 2-pin connector included in the kit.
Firmly push the LED terminals into the 2-pin
connector until they click into position, then lower
the lock.
10. Install the bracket onto the security unit.
5.5 mm
DRILL BIT
UPPER STEERING
COLUMN COVER
CENTER OF THE
UPPER STEERING
COLUMN COVER
UPPER STEERING
COLUMN COVER
LED
PUSH
NUT
2-PIN
CONNECTOR
RED
WIRE
WHITE
WIRE
2-PIN
CONNECTOR
PUSH
NUT
7. While wearing eye protection, lightly center-
punch the mark, and drill a 5.5 mm hole through
the center-punched mark. Remove all burrs.
65 mm
BRACKET
SECURITY UNIT
CONNECTOR
Do not push on
the connector.
