4 of 6
AII 24665 (0210)
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
15. Connect the hood opener cable to the new hood
switch, and position the new hood switch on the
center support at the position you marked in
step 13. Loosely install the three bolts. Shut the
hood, and check that the alignment of the new
hood lock and the hood latch is correct, and
check that the hood is latched securely. When
you’re satisfied with the results, open the hood,
and tighten the hood latch bolts securely.
16. Route the connector end of the hood switch
harness alongside the vehicle harness and under
the windshield wiper fluid bracket toward the
center support on the inside of the left fender and
front bulkhead.
17. Plug the 2-pin hood switch harness connector into
the hood switch 2-pin connector. Push the clip on
the 2-pin connector into the hole in the center stay.
Push the clip on the hood switch into the center
support hole.
NEW HOOD
SWITCH
BOLT
(reused)
HOOD OPENER
CABLE
NEW HOOD
SWITCH
MARK
HOOD SWITCH
HARNESS
To center
stay
14. Remove the hood lock (three bolts, and disconnect
the hood opener cable). Set the hood lock aside; it
will not be reused.
BOLT
(Reuse.)
HOOD LOCK
HOOD OPENER
CABLE
HOOD LOCK
(Set aside.)
FRONT
BULKHEAD
SWITCH
HARNESS
WIRE TIE
FRONT
HOOD
SWITCH
CLIP
2-PIN
CONNECTOR
CENTER
SUPPORT
HOOD
SWITCH
HARNESS
CLIP
