© 2009 American Honda Motor Co., Inc. - All Rights Reserved.
AII 42446 (0908)
9 of 11
33. Position the CD changer on the CD changer
bracket, then install and tighten the four 6 mm
flange nuts.
34. Wrap one EPT sealer around the bus cable
connector from the CD changer, then secure the
bus cable and connector to the CD changer
bracket with the two wire ties you just installed.
35. In the trunk, slide the clip nut into position on the
rear seat panel through the hole in the panel. If
necessary, spread the clip nuts open with a small
flat-tip screwdriver.
36. Loosely install the washer-bolt to the rear seat
panel first. Then place the end of the CD changer
bracket between the seat panel and the clip nut
you just installed.
CLIP NUT
WASHER-BOLT
CD
CHANGER
CD CHANGER BRACKET
(Place the end of the
bracket between the
seat panel and clip nut
you just installed.)
CD CHANGER
BRACKET
CD
CHANGER
WIRE TIES
EPT SEALER
CD CHANGER
BUS CABLE
CONNECTOR
CD
CHANGER
CD CHANGER
BRACKET
4 FLANGE NUTS
