2 of 5
AII 43483 (1010)
© 2010 American Honda Motor Co., Inc - All Rights Reserved.
INSTALLATION
Customer information:
The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers.”
4.
Remove the four washer-screws fastening the
audio unit to the instrument panel and pull the
audio unit out. Unplug the vehicle connector and
antenna lead from the rear of the audio unit and
remove the audio unit.
5.
Remove the four screws and two self-tapping
screws fastening the right and left brackets to the
audio unit and pocket, and separate the pocket
from the audio unit. Save the pocket, screws, and
brackets for your customer.
2624042K
AUDIO
PANEL
5 CLIPS
FLAT-TIP
SCREWDRIVER
GROOVES IN
AUDIO PANEL
2626010K
WASHER-
SCREWS
(Reuse.)
AUDIO UNIT
RIGHT
BRACKET
WASHER-
SCREW
(Reuse.)
SELF-
TAPPING
SCREW
POCKET
(not reused)
LEFT
BRACKET
SELF-
TAPPING
SCREW
2828211K
VEHICLE
CONNECTOR
ANTENNA
LEAD
WASHER-SCREW
(Reuse.)
AUDIO
UNIT
1.
Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2.
Disconnect the negative cable from the battery.
Removing the Parts
3.
Wrap a shop towel around a flat-tip screwdriver,
and insert it into the grooves in the audio panel.
Pull the audio panel out toward you to release the
five clips and remove the audio panel. Take care
not to damage the clips.
