Key Master Plus Manual 2019 V1.0
/
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
10
八
. Error Code:
Er-01: Error in rotating motor or induction light;
Er-02: Error in the push rod motor or front stroke switch;
Er-03: Error in the push rod motor or the medium stroke switch;
Er-04: Error in the push rod motor or the rear stroke switch;
Er-05: Error in the upper and lower motor or upper stroke switch;
Er-06: The upper and lower motor or lower stroke switch is faulty;
Er-07: The left and right motor or left stroke switch is faulty;
Er-08: The left and right motor or right stroke switch is in error;
Er-09: The switch motor or open switch is faulty;
Er-10: Error in switching motor or off-travel switch;
Er-11: The coin code table is offline error;
Er-12: Anti-shake alarm error (self-recovery after ten seconds);
Er-13: The prize code table is offline;
Er-14: Error in calibration or verification operation;
Er-15: Error in the coin acceptor card;
Er-16: Error in the banknote machine;
Er-17: Memory alarm error;
Er-18: Error in the ball returning ball;
九
. Other Important Matters:
9.1 The following test items require special attention and must be operated and tested by
experienced personnel:
* Calibration item: The program will clear all the previously saved coordinate values and then search
for the correct coordinate values. This operation takes about 10 minutes. It is usually used when you
need to completely re-find the coordinates. The suggestion is monthly or indeed Do this only when
you are done;
* Check 1 item: According to the original saved coordinates, check the gift one by one. After
pushing the key of the acrylic board, the golden key head does not rotate and pull out the gift
operation. This operation is only used to check whether the coordinates are correct. This operation
takes less time;
* Check 2 item: According to the original saved coordinates, check the gift one by one. After
pushing the key of the acrylic plate, the golden key head performs the rotating hook and drag the
gift operation. This operation is correct as the complete test coordinate. Whether the rotating hook
and the gift are pulled out correctly, the gift opening and closing door will also have an opening and
closing operation, which takes a long time;
9.2 Inspection and maintenance
Even if the machine is operating normally, in order to allow the machine to operate at its best and
for a longer period of time, please carry out daily inspection and maintenance on the following:
1. The new machine arrives at the location or location, and the automatic calibration test is
performed before the operation;