7
3.If X(left and right)position not right,Press
”CLEAR”Button
，
drill push out and save data.Check the
drill go in or not,if not go in,adjust again.When LED glint then save the position.
4.Press the
“TEST”go to next slot.The drill come back original point after finish all slot.
（
4
）
Confirm origin test mode:
Enter mode 6 method
：
Press button
“
MODE
”
till LED6 bright then get into mode 6.As picture,
1
、
Press
“
ENTER
”
button under mode6
，
test each box position
（
If can’t get into it, back to mode 5 and keep adjusting
）
2
、
Press
“
TEST
”
button under mode 6
，
test motion
（
test each switch and rod’s pushing
）
.
3
、
Under mode 6
，
press
“
UP
”
button will increase 10 tokens
，
press
“
CLEAR
”
one time will clear tokens.
If press
“
CLEAR
”
button more than 10 seconds
，
LED light and Nixie tube will shut down, at the same
time total tokens and total gifts give up will clear.
4
、
Under mode 6
，
press
“
DOWN
”
button more than 10 sec
，
LED light and Nixie tube will shut down, at the
same time will clear blocked token number.
8.
Setting Probability
（
1
）
Setup under mode 7
，
Enter mode 7 method
：
Press
“
MODE
”
button till LED7 bright then get
into mode7. As picture,
