2
www.homewerksww.com
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area where
new faucet will be mounted.
1
4. Insert rubber washers into union
nuts.
Wrench tighten union nuts
to faucet body (do not over
tighten).
4
2. Using thread sealant tape
(wrapped clockwise), or joint
compound, cover all exposed
male thread areas.
Insert faucet spout into faucet
body making sure the O-rings
snap into place. Hand tighten
spout nut over faucet body
threads.
2
5. Install soap dish (optional)
Hand tighten the soap dish
rod into the top of the nut at
the back of the faucet. Place
the soap dish on the threaded
end of the rod with the edge
of the soap dish parallel to the
wall. To adjust, rotate soap dish
clockwise.
Turn on water supply or shut-off
valve and check for leaks.
5
3. Screw flanges onto fine thread
side of swivel unions, flat side
facing away from faucet. Use a
wrench (not included) to tighten
swivel unions onto 1/2 in. stub
out pipes extending from wall.
3
6. Remove aerator from spout.
Turn on faucet and run at least
30 seconds to flush water line.
Turn off faucet and replace
aerator.
6
PRODUCT SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
Max. Flow Rate: 1.8 GPM (6,814 LPM) at 60 PSI
Ceramic cartridges
ASME A112.18.1/CSA B125 certified
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
Meets ANSI/NSF 61-9
Chrome finish
Total weight of item: 2.84 lbs.
ASSEMBLY INSTRUCTIONS
