4
EATON
www.cooperwiring.com
Configuring Device Settings
a) From the web interface, go to your Device Management page and click on the device you wish to configure.
b) Click on the Z-Wave tab.
c) Here you can Rescan, Remove, Test, Optimize, and Audit the node. Associations can also be set here.
d) Expanding the Settings section will allow you to change the wake-up interval for battery operated devices. Here you will also see many settings for different parameters depending on the
device.
e) Below the settings will be Associations which will be available for devices that support associations. Here you can set up companion switches to work with Z-Wave associated master
switches.
STEP #7 – Creating Automation Events
Simply put, an automation event consists of an action
(or actions) that are set into motion by one or more
triggers. Example: Turning on lights at sunset. Trigger =
sunset, Action = turning lights on. With Controller, you
can quickly and easily create all the events you need.
Here’s how to create the sunset event above:
Creating Events
a) From the web interface, use the pull down menus
to navigate to the Events page (VIEW > Events).
b) Change the event group name from “New Group”
to “Lighting”.
c) Now expand the “New Event” section and rename
the new event to “Lights on at Sunset”
d) In the shaded blue “Trigger” section, choose “The
Time Is…” and then select “The Time is Sunset”
e) If the shaded green “Actions” section, choose
“Control a Device” and then select the device
you wish to control and the method of control
(on / off) you wish to use. See image above for
resulting view.
STEP #8 – HSTouch Server Setup
After you have successfully connected to your Wi-Fi network, you must make sure HSTouch Server is properly set up before connecting the client to your HomeSeer system. Follow the
instructions below to set up HSTouch Server.
a) Go to the Plug-in’s menu within your HomeSeer Web Control and click on Manage.
b) If HSTouch Server is not installed follow these steps, otherwise skip to step f
c) Click on Additional Interfaces to expand the plug-in updater.
d) Scroll down to User Interfaces and expand that. Check the box next to HomeSeer HSTouch Sever.
e) Scroll back up and click on Download and Install.
f) Now that HSTouch Sever is installed, it must be enabled for mobile access. Underneath the Enable column, click on the red toggle. It should become green with a check mark in it.
g) HSTouch Server is now enabled. You can now go into HSTouch on your device to configure HSTouch.