HSW-120Z
Z
‐
Wave Dual In-Wall Switch
Introduction:
The HomeScenario HSW-120Z is a low-cost Z-Wave Dual In-Wall Switch Module specifically used to enable Z-Wave command and
control two appliances on/off wirelessly. The HSW120 can work with traditional wall panels, such as Panasonic COSMOS ART and
install in a standard enclosure.
The wireless module is powered from the mains supply and is a three-wire design which requires a neutral connection.
In the event of power failure, non-volatile memory retains all programmed information relating to the units operating status.
It also is a repeater in the Z-Wave network. Acting as a bridge for communication, it will forward Z-Wave command messages to their
destinations if the originating controller is out of range from the destination node.
By taking advantage of the Z-Wave mesh network, commands can be routed to their destination via intermediary “listening” Z-Wave
products. Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
In-Wall Electrical Installation Instructions:
IMPORTANT:
A licensed electrician with knowledge and understanding of electrical systems and electrical safety should complete the
electrical installation inside the main circuit box (usually located outside of your house).
IMPORTANT:
The electricity to the circuit must be shut off during installation for safety and to ensure that wires are not shortcircuited
during insallation which will cause damage to the Micro Module.
The HomeScenario HSW-120Z must first be powered by a 3-wire system in order to operate. The wiring diagram is as follows:
Z-Wave Network Instructions:
The HSW-120Z must be paired (included) into a Z-Wave network before it can receive Zwave commands to turn on/off. The HSW-120Z
can only communicate to devices within it’s own z-wave network.
Note:
The LED on the HSW-120Z will blink if it is currently not paired into a Z-Wave network.
- 1 -
