34
35
Mounting
Start-up
• Insert the plugs into the bore holes.
• Place the wall mounting bracket and turn the
screws into the plug.
• Only insert the motion detector into the wall
mounting bracket after the device has been put
into operation (see sec. „6 Start-up“ on page
35).
5.1.2
Adhesive strip mounting
For the installation with adhesive strips, please proceed
as follows:
• Choose a site for installation.
• Depending on the installation site - wall or corner
- fix the adhesive stripes to the middle or on the
side of the wall mounting bracket
(E)
.
• Remove the protective film and press the wall
mounting bracket
(E)
to the desired location.
Make sure that the mounting surface is smooth,
solid, non-disturbed, free of dust, grease and sol-
vents to ensure long-time adherence.
6
Start-up
Please read this entire section before starting to
use the device.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
To integrate the motion detector into your system and
enable it to communicate with other Homematic IP de-
vices, you must teach-in the device to your Homemat-
ic IP Access Point first.
To teach-in the motion detector, please proceed as fol-
lows:
• Open the Homematic IP app on your smart-
phone.
• Select the menu item
“Teach-in device”
.
• Open the battery compartment
(C)
on the rear
by pushing the battery compartment cover
(D)
down
(see fig. 4)
.
• Remove the insulation strip from the battery
compartment
(C)
of the motion detector to acti-
vate the device. Teach-in mode remains activated
for 3 minutes.
Summary of Contents for HmIP-SMI
Page 3: ...2 3 4 5 D E F G ...
