49
Start-up
5.1.1
Direct pairing with a Homematic IP device
You can directly pair the Homematic IP Radiator
Thermostat – basic (HmIP-eTRV-B) to the
Homematic IP Window / Door Contact with
magnet (HmIP-SWDM) and/or the Homematic IP
Wall Thermostat (HmIP-WTH-B).
Please make sure you maintain a distance of at
least 50 cm between the devices.
You can cancel the pairing procedure by briefly
pressing the system button
(D)
again. This will be
indicated by the device LED
(D)
lighting up red.
To connect the device with another Homematic IP device,
the pairing mode of both devices has to be activated. To
do this, please proceed as follows:
• Open the battery compartment
(B)
by pulling the
battery compartment down
(see figure 3)
.
• Remove the insulation strip from the battery
compartment.
• Press and hold down the system button
(D)
for
at least 4 seconds to activate the teach-in mode
(see figure 4)
. The device LED
(D)
starts to flash
orange. Pairing mode remains activated for 3
minutes.
• Press and hold down the system button of
the device you want to connect (e.g. the
Summary of Contents for HmIP-eTRV-B
