40
Restore factory settings
1x orange and
1 x green light-
ing (after insert-
ing batteries)
Test display
Once the test dis-
play has stopped,
you can continue.
8
Restore factory settings
Thez factory settings of the device can be
restored. If you do this, you will lose all your
settings.
To restore the factory settings of the window / door con-
tact, please proceed as follows:
• Pull the cap
(D)
off the electronic unit
(B)
. There-
fore, press the latch of the cover downwards and
pull down the cover afterwards
(see fig. 2)
. You
will find the battery compartment below
(E)
.
• Remove a battery.
• Insert the battery ensuring that the polarity is cor-
rect and press and hold down the system button
(A)
for 4 seconds at the same time, until the LED
will quickly start flashing orange
(see figure 3+7).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart.
Summary of Contents for HMIP-SWDO-I
Page 3: ...1 A B E D C ...
Page 4: ...3 2 ...
Page 5: ...4 2 3 mm 15 mm ...
Page 6: ...6 5 7 2 3 mm 15 mm Fenster Querschnitt Window cross section ...
