33
Hazard information
The actuator is part of the building installation.
The relevant national standards and directives
must be taken into consideration during planning
and set-up. The device has been designed solely
for operation on a 230 V/50 Hz AC supply. Only
qualified electricians (to VDE 0100) are permitted
to carry out work on the 230 V mains. Applicable
accident prevention regulations must be
complied with whilst such work is being carried
out. To avoid electric shocks from the device,
please disconnect the mains voltage (trip the
miniature circuit-breaker). Non-compliance with
the installation instructions can cause fire or
introduce other hazards.
SELV/PELV power circuits may not be connected
to the switching output.
When connecting to the device terminals, take
the permissible cables and cable cross sections
into account.
Connected loads require sufficient insulation.
Please take the technical data (in particular the
maximum permissible switching capacity of the
relay and the type of load to be connected) into
account before connecting a load! All load data
Summary of Contents for HmIP-FSI16
Page 3: ...1 A B E C D F ...
Page 4: ...2 3 OFF ...
Page 5: ...4 5 ...
